We use cookies to improve your online experience. By continuing browsing this website, we assume you agree our use of cookies.
We use cookies to improve your online experience. By continuing browsing this website, we assume you agree our use of cookies.
By Penny:+86 186 2027 9358 Julie:+86 18520495887 | 03 January 2025 | 0 Comments

The reasons why the Semi trailer brake does not return may be as follows

The reasons why the Semi trailer brake does not return may be as follows:
1. Brake return spring breaks or loses elasticity, resulting in the brake pedal can not be reset in time. The brake pedal return spring needs to be replaced.
2. The brake caliper piston is stuck, which prevents the normal operation of the brake system and causes the brake not to return. Solving this problem requires checking and repairing the calipers to ensure their flexible operation.
3. The rear axle bearing is fixed or installed improperly, or the bearing is worn, which will also lead to the brake not returning. It is recommended to adjust the fixing and installation of rear wheel bearings and replace worn bearings if necessary.
4. The brake oil is too dirty or the internal valve of the main pump is faulty, which affects the normal flow of the brake oil and causes the brake system to not work normally. To this end, it is necessary to replace the brake oil and check the internal valve of the main pump to ensure its smooth operation.
In addition, brake pads and brake discs (drums) have a limited service life and must be replaced when worn to a certain extent. When replacing brake pads, it should be noted that the rubber edge that has not been moved for a long time may be adhered to the edge of the guide sleeve. The travel of the new brake pads is different from the old ones, which may cause damage to the rubber sleeve or poor movement. If the lubricant is used when replacing the brake pads, it may accelerate the aging of the rubber, so that the rubber sleeve is deformed after being inserted into the guide sleeve, which is easy to lead to adhesion. Therefore, in order to ensure the normal operation of the brake system, it is necessary to pay attention to the condition of the brake pads and brake discs.

Leave a Reply

Your email address will not be published.Required fields are marked. *
Name
E-mail
Content
Verification code
ver_code
CATEGORIES